In particular, you need to know the port numbers and the
protocol (TCP, UDP) used by outgoing traffic.
• Dropped — Internet traffic is blocked by default. Only traffic
from the selected pre-defined or custom applications are
allowed to access the Internet.
Click Apply.
Enable VPN Passthrough
If you want to connect to a corporate network using VPN, you
first need to enable VPN connections (passthrough).
To enable VPN passthrough:
On the AT&T Wi-Fi Manager home page, log in as
Administrator.
Click Settings on the navigation menu on the left side.
Click Advanced > Router tab.
In the VPN Passthrough section, select Enable beside VPN
Passthrough, and click Apply.
Configure APN Details
The APN is checked to determine the type of network
connection to establish. Your mobile hotspot comes
preconfigured with the APN (Access Point Name) for AT&T.
To add an APN for another network:
On the AT&T Wi-Fi Manager home page, log in as
Administrator.
47Advanced SettingsAdvanced Settings46
Click Settings on the navigation menu on the left side.
Click Network > APN tab.
Click Add.
Enter the profile name and APN (obtained from your carrier).
Select the network Authentication mode. The options are:
• NONE (default)
• CHAP
• PAP
Enter the User Name and Password, if these are required for
the wireless network.
Click Save.
To select the APN entry to use:
From the drop-down box beside Profile Selection, select the
desired APN to use.
To remove an APN entry:
Select the APN you want to remove, and click Delete.
Enable DMZ
In a DMZ (demilitarized zone) network configuration, a
computer runs outside the firewall in the DMZ. This computer
intercepts incoming Internet traffic, providing an extra layer of
protection for the rest of the network.
AT&T Velocity – User Guide – Postpaid AT&T Velocity – User Guide – Postpaid
To Next Page
Loading...
