12
1. Locate the SIM tray on the left hand side panel. Insert a
pin into the small hole at the bottom of the SIM tray.
2. Place the nano-SIM card into the smaller section of the
tray, add a microSD card (optional) if you need more
storage (memory) in the device.
3. Replace the SIM tray
Charging the Phone
Your phone’s battery should have enough power for the
phone to turn on, find a signal, and make a few calls. You
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE-approved chargers and USB cables. The use
of unapproved accessories could damage your phone or
cause the battery to explode.
The battery is NOT user replaceable. Do not attempt to open
the case or remove the battery as this will damage your
device.
NOTE:
If the battery is extremely low, you may be unable to power
on the phone even when it is being charged. In this case, try
again after charging the phone for at least 20 minutes.
Contact the customer service if you still cannot power on the
phone after prolonged charging.
To Next Page
Loading...
Need help?
General
