Zte MF58 - Setting Other User Numbers

ZTE MF58
25
can make a video call with the Mobile Cam. In the default situation, the Mobile Cam will
sound a beep to notify AD that the AD number is set (It can be set by SMS command that
whether the beep switch is on or off). After 3 consecutive incorrect PIN code entries, or if
you have not been able to enter the PIN code within 60 seconds, the Mobile Cam will be
disconnected automatically. If the PIN code is correct, AD will enter the video call interface.
Note:
Once you set the AD number on the Mobile Cam, you can check or revise the time by SMS.
For details, please refer to the section on SMS command operation.
The AD number should be set in ZTE network, using a local number. An attempt to set the
number from outside ZTE network using a mobile roaming or IDD service will result in an
invalid number being saved in the white list.
Setting other user numbers
In addition to the AD, other phone numbers will be added to the white list (maximum 20
numbers in the white list, including the AD) when making a video call to the Mobile Cam
with a correct PIN code entered.
First, make a video call to the Mobile Cam using a non-AD number.
This Manual: http://www.manuallib.com/file/2593400