ZTW BEAST PRO Series - User Manual

To Next Page

200A & 300A

● Enhanced throttle response, excellent acceleration, linearity and driveability.

● Using the advanced PC interface allows you to set up, program or update the ﬁrmware.

● Fully programmable via LCD program card, PC interface .

● Adjustable BEC output 6.0/7.4V, up to 8A current output.

● Multiple protection features: Low voltage cut-oﬀ protection, over-heat protection and throttle signal loss protection.

● Double fan cooling system:one outside, one inside.

Features

Speciﬁcation

1:5 Beast Pro 200A 8S 1:5 Beast Pro 300A 12S

Continuous Current

Burst Current(10s)

BEC

Battery NiXX/Lipo

Width

Length

Height

Weight

Programmable

Suitable car

Suitable car weight

Waterproof

200A

1300A

6.0V/7.4V Adjustable/8A

8-24NC/3-8SLipo

55mm

90mm

50mm

407g

Yes

1:5 Buggy/Truck

＜13kg

Yes

300A

1800A

6.0V/7.4V Adjustable/8A

18-36NC/6-12SLipo

74mm

115mm

78mm

500g

Yes

1:5 Buggy/Truck

＜15kg

Yes

① (Short) Program wire ② (Long) Singal wire

③ Switch ④ Motor wire A

⑤ Motor wire B ⑥ Motor wire C

⑦ Power wire(+) ⑧ Power wire(-)

① (Short) Program wire ② (Long) Singal wire

③ Switch ④ Motor wire A

⑤ Motor wire B ⑥ Motor wire C

⑦ Power wire(+) ⑧ Power wire(-)

Verify each wire is connected correctly per the diagram below.

Initial Installation Pro Line ESC

User Manual

ZTW Beast series senscored/sencorless brushless ESC for 1:5 scale car.

Thank you for purchasing the ZTW Brushless Electronic Speed Controller (ESC). The ZTW BEAST PRO Series 200A、300A ESC are high quality and high

performance ESC which can be used for 1:5 scale truck and buggies. Beast PRO series ESC are well designed and tested and ﬁne-tuned by the

experienced driver proven to be a reliable quality ESC. On top of this, we make it more resistant to water. You can run your vehicles through the morning

dew, down the muddy road, across the soggy snow or just about anywhere else you’d be interested in running. In order to operate this ESC properly please

read this manual thoroughly before use. ZTW Model have no control over the correct use, installation, application or maintenance of these products, thus no

liability shall be assumed nor accepted for any damages, losses of costs resulting from the use of this item. Any claims arising from the operating, failure or

malfunction etc. will be denied. We assume no liability for personal injury, property damage or consequential damages resulting from our product or our