Need help?Do you have a question about the ZTW Mantis Series and is the answer not in the manual?
General| Programmable | Yes |
|---|---|
| LiPo Cells | 2-3S |
| BEC Output | 5V |
| PWM Frequency | 8KHz |
| Protection Features | Low-voltage |
| Input Voltage | 2S-3S LiPo |
ESC reduces output power when temperature exceeds 110°C to cool down.
ESC cuts power to the motor upon lost throttle signal for 2 seconds.
Configure brake intensity (Off, Soft, Mid, Hard) for different prop types.
Select battery chemistry (NiCad/NiMH/LiPo) for proper operation.
Resets all ESC parameters to their original factory default values.
Adjust motor timing (Auto, Low, High) for optimal performance.
Select output voltage (5.0V, 5.5V, 6.0V) for BEC.
Configure governor mode for helicopter operation (e.g., OFF).
Select delay time (Soft Start 1, Soft Start 2) for smooth acceleration.
For Low KV motors, maintains RPM by detecting and compensating lost RPM.
For High KV motors, maintains RPM by detecting and compensating lost RPM.
Choose between reducing power or hard cutoff on low voltage.
Addresses motor not working but ESC signals cell count, often due to calibration.
Troubleshooting poor connections, power issues, or incorrect polarity.
Diagnoses issues like loose connections, burnt coils, or incorrect throttle position.
Identifies reversed throttle channel causing ESC to enter programming mode.
To Next Page
