ZTW Beast Pro 220A - User Manual

User Manual
120A & 160A & 220A
ZTW Turbo Series Brushless Speed Controller for 1:10 &1:12 scale Car or Truck
Thank you for your purchasing the ZTW Brushless Electronic Speed Controller (ESC). The ZTW
electronic speed controller is specifically designed for operating Sensored/Sensorless brushless
motors. High power systems for RC model can be very dangerous and we strongly suggest that
you read this manual carefully. ZTW Model have no control over the correct use, installation,
application or maintenance of these products, thus no liability shall be assumed nor accepted for
any damages, losses of costs resulting from the use of this item. Any claims arising from the
operating, failure or malfunction etc. will be denied. We assume no liability for personal injury,
property damage or consequential damages resulting from our product or our workmanship. As
far as is legally permitted, the obligation for compensation is limited to the invoice amount of
product in question.
Features
◆ Enhanced throttle response, excellent acceleration, linearity and driveability.
◆ Using advanced PC interface to set up or update the firmware.
◆ Using LCD program card to make adjustments.
◆ Throttle curve and punch rate adjustment
◆ Dynamic boost timing and turbo timing adjustment.
◆ Brake curve and brake rate adjustment.
◆ Dynamic running data log.
◆ Multiple protection features: Low voltage cut-off protection, over-heat protection and throttle
signal loss protection.
Turbo Series Brushless System specification
Model
PN#Model
Cont.Current
Brust Current
Suitable Car
Battery cell
BEC Output
Dimension(l*w*h)
Weight(g)
6212020
120A
760A
1:10/1:12 Car
2-3s Lipo/ 5-10s NiMH
6V/3A
41.5*37*21mm
102g
6216020
160A
760A
1:10/1:12 Car
2-3s Lipo/ 5-10s NiMH
6V/3A
41.5*37*21mm
102g
4222032
220A
1000A
1:8 Car
8-18NC/3-6s Lipo
6.0V/7.4V Adjustable/8A
55*40*34mm
140g
Beast Pro 120A Beast Pro 160A Beast Pro 220A

Summary

Throttle Range Calibration

General Setting

Cut-off voltage

Protects LiPo batteries from over-discharge by limiting output power.

Boost Timing

End RPM

Sets the motor RPM threshold where boost timing reaches its maximum value.

Turbo Timing

Activation Method

Specifies conditions (Full Throttle, RPM, or both) required for turbo activation.

Turbo Delay

Sets the required continuous full throttle time before turbo activation.

Start RPM

Defines the minimum motor RPM required for turbo activation.

Turbo Slope ON

Turbo Slope “OFF”

Turbo LCD Program Card

How to connect the LCD program card

Provides step-by-step instructions for connecting the program card to the ESC.

Operation

Explains the functions of the buttons (Menu, Value, Note, Reset, OK) for programming.

ZTW Beast Pro 220A Specifications

General

Brand	ZTW
Model	Beast Pro 220A
Category	Controller
Language	English