ZTW Mantis Series User Manual

Frequently Asked Questions
Q: Motor does n't work, but there are audible tones signal the number of cells after powering
up ESC
Possible cause: The ESC throttle calibration has not set up.
Possible Solution: Set up the ESC throttle calibration
Q: Motor does n't work and no audible tone emitted after connecting the battery. Servos are
not working either.
Possible cause:
1. Poor/loose Connection between battery Pack and ESC.
2. No power
3. Poor soldered connections (dry joints)
4.Wrong battery cable polarity
5. ESC throttle cable connected to receiver in the reverse polarity
Possible Solution: Check all the connections make sure you are doing it right.
Q: Motor does not work but servos do
Possible Cause:
1. Poor / loose connection between ESC and motor
2. Burnt motor coils
3. The battery pack voltage exceeds the acceptable range.
4. Throttle stick is not at the lowest position
5. The battery pack voltage exceeds the acceptable range.
Q: Motor does not work but beeps like in the programming mode
Possible Cause: Reversed throttle channel caused the ESC to enter the programming mode.
9
BatteryType
Cut Off Voltage
Threshold
Restore Factory
Setup Defaults
Motor Timing
SBEC Voltage
Output
Governor Mode
Motor Rotation
Start Up Strength
Low Voltage Cut
Off Type
NiCd/NiMH
Lipo
LiFe
2.8V/50% 3.0V/60% 3.2V/65%
No
Protection
Restore
Auto
2°
8° 15°
22°
30°
5.0V
5.5V
6.0V
RPM OFF
st
1 Soft Start
Governor
Mode 1
Governor
Mode 2
Forward
Reverse
10% 15% 20% 25% 30% 35% 40% 45% 50%
Reduce
Power
Cut Off
Power
Note: Highlighted value are default settings.
nd
2 Soft Start

ZTW Mantis Series Specifications

General

Brand	ZTW
Model	Mantis Series
Category	Controller
Language	English