49
EN
WARNING: Any action to unblock the machine must be carried out by disconnecting it
from the mains. If, after making the checks stated here, the machine does not work, call the
technical service.
DETECTING FAULTS
FAULT POSSIBLE CAUSE CORRECTION
THE MACHINE DOESN’T
WORK
Machine not plugged in. Plug it in.
No power is reaching the plug. Check the socket.
Cover not tted properly. Make sure it has been t properly.
Juice container not tted properly. Make sure it has been t properly.
Blocked pressing units. Turn off the machine at the mains
and unblock the pressing units.
Safety sensors malfunctioning. Contact your technical service.
Faulty ON/OFF button. Contact your technical service.
Faulty circuit. Contact your technical service.
THE MACHINE BLOCKS
FREQUENTLY DURING
JUICING
Insufcient voltage. Check that the voltage matches
that indicated in the manual.
Faulty circuit. Contact your technical service.
THE PRESSING UNITS ARE
NOT SYNCHRONIZED
Fault in an axle. Contact your technical service.
PEEL EJECTOR BREAKS Peel ejector incorrectly tted. Place it in its correct position
inserting it totally until observing it
has madecontact (Fig. 8)
YOU CAN HEAR THE MOTOR
RUNNING BUT THE PRESSING
UNITS ARE NOT TURNING
Internal fault. Contact your technical service.
THE FAUCET GETS BLOCKED The juice has seeds or too much
pulp.
Disassemble and clean the faucet
according Fig. 11A.
FAULT POSSIBLE CAUSE CORRECTION
THE MACHINE STOPS EVERY
NOW AND AGAIN
Insufcient ventilation. Check that the appliance’s
ventilation grilles are not blocked.
Overload. Contact your technical service.
SCREEN DOES NOT DISPLAY
INFORMATION
Alteration to mains systems. Turn off the machine and turn it
back on again.
THE MACHINE IS IN SELF-
SERVICE MODE AND WON’T
STOP OPERATING
Faucet not tted or tted
incorrectly.
Fit the faucet in the manner
indicated in Fig. 11A
Faucet well tted: possible internal
fault.
Contact your technical service.
Faucet block activated. Put the block in horizontal position
by pressing the faucet downwards.
SCREEN MESSAGES
DISPLAY MESSAGE CAUSE CORRECTION
EXCESS CURRENT The maximum electrical
consumption level has been
exceeded for at least one second.
Turn off at mains and turn back
on again.
NO ORANGES The motor remains on for two
minutes detecting any squeezing.
Put oranges back in feeder again
without and press ON.
MEMORY INITIATED A memory error has been detected. Contact your technical service.
CALIBRATION An incorrect calibration value has
been detected.
Calibrate (See page 18).
To Next Page
Loading...
