STEP 2 – INFLATE THE PADDLE BOARD
Find the tips and the detailed steps to inflate the SUP from here.
Tips!
1. You can turn the electric pump into an inflatable SUP pump with
the Pump Adapter (in the Tool Kit).
11
2. About the PSI reading. It should NOT be over 15 PSI. The pump shows no reading for 0-5 PSI (see fig.1). The 12-13 PSI is
recommended for hot weather while it can be up to 15 PSI in cool weather (see fig.2 and fig.3)
Let’s inflate the paddle board.
a. Connect the hose with the pump where the “IN” is on.
b. Turn the valve anticlockwise.
c. Ensure the stem (the white part) is locked (up).
d. Connect the other end of the hose to the core of the valve, and turn the lock clockwise.
e. When inflating, you can change the pumping system by adjusting the Green Lever (see below). When the reading shows
from 0 – 8 PSI, we recommend you turn the Green Lever left to the SINGLE ACTION so that it would inflate to 15 PSI
much easier; when the reading is over 8 PSI, it would inflate faster if you turn it right to the DOUBLE ACTION.
1 2
2
1
3
To Next Page
