Congratulations! Your Zupapa inflatable SUP without a seat is ready to go!
1416
STEP 4 – ASSEMBLE THE KAYAK SEAT
Please note that this step ONLY applies to the model with the kayak seat.
a. Place the seat on the board.
b. Tie the two lower straps with the two D rings behind the backrest. See fig. b below.
c. Tie the two upper straps with the two D rings beside the seat. See fig. c below.
• You can get a comfortable seat by adjusting the straps.
• Please do NOT sit on the SUP when it is still on the ground and with the fins
assembled, because it may damage the item, which will also void the warranty.
IMPORTANT
ba
c
To Next Page
