Set Local Policy to be the ZyWALL/USG local IP address that can use the VPN
tunnel and set Remote Policy to the peer ZyWALL/USG local IP address that can
use the VPN tunnel. Click OK.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Configuration)
This screen provides a read-only summary of the VPN tunnel. Click Save.
Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings
(Summary)
Now the rule is configured on the ZyWALL/USG. The Phase 1 rule settings appear in
the VPN > IPSec VPN > VPN Gateway screen and the Phase 2 rule settings appear
in the VPN > IPSec VPN > VPN Connection screen. Click Close to exit the wizard.
Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings >
Wizard Completed
To Next Page
Loading...
