If you see [alert] log message shown as below, the Wi-Fi guest traffic failed. Please
make sure you enable Web Authentication and check your AD server is working
properly.
Monitor > Log
How to Set Up IPv6 Interfaces for Pure IPv6 Routing
This example shows how to configure your ZyWALL/USG WAN and LAN interfaces
which connects two IPv6 networks. ZyWALL/USG periodically advertises a network
prefix of 2002:1111:1111:1111::/64 to the LAN through router advertisements.
ZyWALL/USG with Pure IPv6 Network Example
Note: The default setting of Security Policy is without log notification (except
PolicyDefault), if you want to check which policy may potentially block the traffic, please
select this policy and set the Log matched traffic to be log or log alert.
To Next Page
Loading...
