CONFIGURATION > Network > Interface > Ethernet > lan1 > General Settings
CONFIGURATION > Network > Interface > Ethernet > lan1 > IPv6 Router
Advertisement Setting
Set Up the 6to4 Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Tunnel > Add
and select Enable. Enter tunnel0 as the Interface Name and select IPv6-in-IPv4 as
the Tunnel Mode. Select wan1 as the gateway interface. Enter your Remote
Gateway Address (172.121.123.150 in this example). Click OK.
To Next Page
Loading...
