How to set up Link Aggregation Group (LAG)
A Link Aggregation Group (LAG) allows you to combine a number of physical ports
together to create a single high bandwidth data path. It helps to implement the
traffic to perform load balancing or failover features, depending on the situation of
the actual case.
LAG interface supported models: ZyWALL 310/1100/1900, USG 310/1100/1900/2200,
ATP500/700/800, USG FLEX500/700, VPN300/1000.
The link aggregation supported models have Active-backup, 802.3ad (LACP), and
Balance-alb modes. Link aggregation supports IPSec tunnel, VLAN, and bridge
interface.
Device HA Pro is supported on the LAG interface.
Set up the Active-backup, 802.3ad, Balance-alb
Active-backup Mode:
(Does not require switch configuration and one or multiple switches can be used.)
To Next Page
Loading...
