To test whether or not a tunnel is working, ping from a computer at one site to a
computer at the other. Ensure that both computers have Internet access (via the
IPSec devices).
PC behind ZyWALL/USG (HQ) > Window 7 > cmd > ping 192.168.20.33
PC behind ZyWALL/USG (Branch) > Window 7 > cmd > ping 10.10.10.33
What Could Go Wrong?
If you see below [info] or [error] log message, please check ZyWALL/USG Phase
1 Settings. Both ZyWALL/USG at the HQ and Branch sites must use the same Pre-
Shared Key, Encryption, Authentication method, DH key group and ID Type to
establish the IKE SA.
MONITOR > Log
To Next Page
Loading...
