C1000Z Quick Start Guide
6
settings.
If you do not set wireless security then anyone within range could use
your C1000Z to access your network and the Internet.
Choose
W
PA-PSK wireless security if your wireless device supports it
as it is stronger than
W
EP. Otherwise choose
W
EP.
1 Select Active and click Next to continue. It i s s
t
rongly recommended
that Enable OTIST i s NOT selected.
See section 7 for more information.
2 Configure your wireless settings i n the screen. Click Next.
3 If you select either WEP or WPA-PSK security (recommended), then
follow the directions to enter the appropriate key. Click Next to continue
and Apply to save your wireless LAN settings.
4 Check your configuration and write down your wireless LAN settings for
later use. Click Finish to complete and save the wizard setup.
5 Your Internet i s ready for you to use. Open your browser and navigate
to your favorite website.
4
Internet Connection
Setup Using
Advanced
Settings
Use
t
his section to set up your Internet connection manually if you do not
To Next Page
Loading...
