5
3. USB: You can connect a USB memory stick or a USB hard drive for
file sharing. The Device automatically detects the USB device.
Alternatively, use a USB cable (not provided) to connect a USB
printer to this port.
4. VOIP: Use a telephone cable (and any telephone adaptor provided
with your C2100Z) to connect a telephone to the VoIP 1 or VoIP 2
port. If you only have one telephone, you should use port 1.
5. HPNA: Use a coaxial cable to connect to a coaxial outlet and relay
Internet traffic throughout your house through coaxial cabling.
6. POWER: Use the provided power adaptor to connect the POWER
socket to an appropriate power source. Make sure the power at the
outlet is on. After connecting the power adaptor, look at the lights on
the front panel.
•The POWER light blinks while your Device starts up and then stays
on once it is ready.
•The DSL lights are either amber or green (depending on your
configuration method, see Internet Connection Setup) when your
Device has a DSL connection.
•The INTERNET light turns on when the gateway is able to access
the Internet and will blink when your Device is sending or receiving
data.
•The WAN/LAN light is on if the WAN/LAN port is properly connected
and blinks when there is traffic.
• Each ETHERNET light is on if the corresponding LAN port is
properly connected and blinks when there is traffic.
•The USB light turns on when there is a USB printer or memory
device is connected to the Device and blinks when transmitting data.
•The Wi-Fi 2.4G light is green when the wireless LAN is ready and
blinks when there is traffic.
•The Wi-Fi 5G light is green when the wireless LAN is ready and
blinks when there is traffic.
To Next Page
Loading...
