Chapter 8 Monitor: Port
GS1900 Series User’s Guide
71
Fig ure 73 Monitor > Port > Port > Bandwidth Utilization
Each field is described in the following table.
8.3 Po E
Note: The PoE function and the following screens are available for models ending in “HP”
only.
The Switch supports both the IEEE 802.3af Power over Ethernet (PoE) and IEEE 802.3at High Power over
Ethernet (PoE) standards. The Switch is Power Sourcing Equipment (PSE) because it provides a source of
power through its Ethernet ports, and each device that receives power through an Ethernet port is a
Table 28 Monitor > Port > Port > Bandwidth Utilization
LABEL DESCRIPTIO N
Bandwidth Utilization
1Gbps This field displays the 1Gbps.
100Mbps This field displays the 100Mbps.
10Mbps This field displays the 10Mbps.
Link down This field displays the link down.
Refresh period This field displays the refresh period.
IFG This field displays the IFG.
Tx Transmitted (Tx) traffic during the last time interval in seconds.
Rx Received (Rx) traffic during the time interval in seconds.
To Next Page
Loading...
