ZyXEL Communications LTE7490-M904 - Document Conventions; Syntax Conventions

3/4
x4
Unit: mm
25.4
8.0
1
3
96mm
96mm
2
Four Nylon Wall Plugs
Wall Mounting (Optional)
Use the four corner holes of the M bracket to mark holes on a wall. Drill four holes in a wall.
1 2
Insert the screw anchors and screws into the holes.
M4 Screws
Unit: mm
x4
25.4
4.0
2.38
9
Insert nylon wall plugs into the wall. Use mounting screws to secure the main frame to the wall
through the nylon plugs.
3
Use washers, spring washers, and nuts to attach the M-type bracket to the back of the
LTE7490.
Follow steps 4-5 in the drawing to align the rotating bracket with the M-type bracket, insert the
M8 bolt through the holes, and use washers, spring washers, and nuts to secure it.
Follow steps 2-3 in the drawing to attach the rotating bracket to the mounting main frame
using washers, spring washers, and hex nuts. Do not tighten the nuts until you adjust the
mounting angle in the final step.
1
32
Spring Washers
x2
M6 Hex NutsM Bracket Bracket-1
Main Frame
x2
x2x1
x1
x1
Washers
Step 5 Pole / Wall Mounting: Connect M Bracket and Main Frame
M8 Spring Washers
x2
M8 Screws
x2
x2
M8 Washers
M8 bolt
x1
-
1
2
3
4
5
5-4