Chapter 2 Hardware
NR/FWA Outdoor Series User’s Guide
25
2.4 WiFi/WPS Button
Use the WiFi/WPS button on the Zyxel Device to turn on/off the WiFi network or quickly build a WiFi
connection with a WiFi client.
Use the WiFi function of the Zyxel Device for configuration (for example, connect to the Zyxel Air app on
your mobile device to find the optimal NR/LTE signal strength and manage your Zyxel Device).
See Section 1.1.1 on page 16 to check if your Zyxel Device has a WiFi/WPS button.
Note: You can also find a WPS button on the Web Configurator.
Figure 13 NR7101 WiFi/WPS Button
To turn on WiFi:
1 Make sure the LED is on and not blinking.
2 Press the WiFi/WPS button for more than 5 seconds and release it.
Once WiFi is turned on, the LED blinks amber.
To activate WPS (WiFi must be already on):
You can also quickly set up a secure WiFi connection between the Zyxel Device and a WPS-compatible
client by adding one device at a time.
1 Press the WiFi/WPS button for more than 1 second but less than 5 seconds and release it (pressing more
than 5 seconds will turn off WiFi).
2 Press the WPS button on another WPS-enabled device within range of the Zyxel Device.
Note: If the WPS-enabled device is placed too far, it will not be able to connect to the Zyxel
Device.
Once a WiFi connection is ready, the LED blinks amber.
To turn off the WiFi network:
Press the WiFi/WPS button for more than 5 seconds.
The amber LED turns off.
To Next Page
Loading...
