ZyXEL Communications P-660H Series - Figure 111 Telnet Configuration on a TCP;IP Network; Table 80 Remote Management: WWW; Telnet; Configuring Telnet

P-660H/HW-D Series User’s Guide
Chapter 15 Remote Management Configuration 204
The following table describes the labels in this screen.
15.3 Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 111 Telnet Configuration on a TCP/IP Network
15.4 Configuring Telnet
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Table 80 Remote Management: WWW
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click Apply to save your settings back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.