P-661HW-D Series Support Notes
(3) On the SUMMARY menu, select a policy to edit by clicking Edit. On
P-661HW-D, we can build at most 2 VPN Tunnels. Just make a click on the
‘Edit’ button in the table, we can begin to configure the VPN rule.
(4) In the IPSEC Setup field, toggle Active check box and give a name, Test
in the example to this policy.
Select IPSec Key Mode to IKE, Negotiation Mode to Main, and
Encapsulation Mode to Tunnel, just the same as we will configure in Prestige
B.
(5) Fill in the Local and Remote secure hosts information in the Local and
Remote field.
Local Address Type is Single and IP Address Start is PC 1’s IP,
192.168.1.33 in the example.
Remote Address Type is Single and IP Address Start is PC 2’s IP,
192.168.2.33 in the example.
99
All contents copyright © 2006 ZyXEL Communications Corporation.
To Next Page
Loading...
