P-661HW-D Series Support Notes
Example
The following example shows how to dial to an ISP via the P-661HW-D and
then establish a tunnel to a private network. There will be three items that you
need to set up for PPTP application, these are PPTP server (WinNT), PPTP
client (Win9x) and the P-661HW-D.
(1) PPTP server setup (WinNT)
• Add the VPN service from Control Panel ->Network
• Add an user account for PPTP logged on user
• Enable RAS port
• Select the network protocols from RAS such as IPX, TCP/IP NetBEUI
• Set the Internet gateway to P-661HW-D
(2) PPTP client setup (Win9x)
• Add one VPN connection from Dial-Up Networking by entering the
correct username & password and the IP address of the P-661HW-D's
Internet IP address for logging to NT RAS server.
• Set the Internet gateway to the router that is connecting to ISP
(3) P-661HW-D setup
• Before making a VPN connection from Win9x to WinNT server, you
need to connect P-661HW-D router to your ISP first.
• Enter the IP address of the PPTP server (WinNT server) and the
port number for PPTP as shown below:
59
All contents copyright © 2006 ZyXEL Communications Corporation.
To Next Page
Loading...
