P-661HW-D Series Support Notes
Step 1: In this case, we need to map ILA to more than one IGA, therefore we
must choose the Full Feature option from the NAT field in currently active
remote node, and assign IGA3 to P-661HW-D’s WAN IP Address.
Step 2: Go to Web Configurator, Advanced Setup, Network -> NAT ->
Address Mapping to begin configuring Address Mapping Set #1. We can see
there are 10 blank rule table that could be configured. See the following setup
for the four rules in our case.
Rule 1 Setup: Select One-to-One type to map the FTP Server 1 with ILA1
(192.168.1.10) to IGA1 (200.0.0.1).
Rule 2 Setup: Selecting One-to-One type to map the FTP Server 2 with ILA2
(192.168.1.11) to IGA2 (200.0.0.2).
70
All contents copyright © 2006 ZyXEL Communications Corporation.
To Next Page
Loading...
