Quick Start Guide
PMG5317-T20B
Wireless N GPON HGU with 4-port
GbE Switch and USB
ENGLISH
Connect the fiber optic cable from your service
provider's network to the PON port.
Warning! To avoid possible eye injury, do NOT
look into an operating fiber-optic module's
connector.
Connect a phone to the phone port using the phone cable.
Connect a computer to the LAN port using the yellow
Ethernet cable.
Connect the power cable to the modem and press the
power button.
Note: Only use the USB port for file sharing.
Make sure the LEDs are on and check the status.
EN
1
Configuring your PMG5317-T20B
Open a web brower and go to http://192.168.1.1
Enter the default User Name (admin) and Password (1234), then
click Login.
2
3
4
EN
5
PMG5317-T20B
User Name
Password 1234
admin
1
Hardware Connections
LAN
Internet Setup
Login
User Name : admin
Password : 1234
(default)
http://192.168.1.1
1
5
PHONEPON POWER
43
2
POWERBATTALMPONINTERNETLANPHONEUSB
WLAN/
WPS
1
3
4 1
2
2
POWER
PON
1
LAN
On: Power on and system ready.
Off: Power off.
1
PHONE
On : Registered to IMS but no voice
communication.
Blinking: Voice on communication.
Off: No registered SIP accounts to this line,
or device power off.
On: Linked successfully.
Blinking: Trying to link up.
Off: Link off.
On : Linked successfully. (Any LAN port)
Blinking: Data transmitting.
Off : Link off.
1/2
2
2
1
4
1
3
POWER ON
To Next Page
Need help?
General
