ZyXEL Communications PX3321-T1 - E-Mail Notification Edit

Chapter 40 Email Notification
AX/DX/EX/PX Series User’s Guide
483
The following table describes the labels in this screen.
40.2.1 E-mail Notification Edit
Click the Add button in the E-mail Notification screen. Use this screen to configure the required
information for sending email through a mail server.
Figure 270 Maintenance > E-mail Notification > Add
The following table describes the labels in this screen.
Table 187 Maintenance > E-mail Notification
LABEL DESCRIPTION
Add New e-mail Click this button to create a new entry (up to 32 can be created).
Mail Server
Address
This displays the server name or the IP address of the mail server.
Username This displays the user name of the sender’s mail account.
Port This field displays the port number of the mail server.
Security This field displays the protocol used for encryption.
E-mail Address This field displays the email address that you want to be in the from or sender line of the email
that the Zyxel Device sends.
Modify Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Remove Click this button to delete the selected entries.
Table 188 Maintenance > E-mail Notification > Add
LABEL DESCRIPTION
Mail Server
Address
Enter the server name or the IP address of the mail server for the email address specified in the
Account e-mail Address field.
If this field is left blank, reports, logs or notifications will not be sent through email.
Port Enter the same port number here as is on the mail server for mail traffic.
Authentication
Username
Enter the user name. You can use up to 32 printable characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [
^ ], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed. This is usually the user name of a mail account
you specified in the Account email Address field.