ZyXEL Communications USG40W - Page 109

109/255
www.zyxel.com
7 Go to CONFIGURATION > Network > Interface > Trunk > User Configuration >
Add to create a new trunk. Add vti1 and vti2 to the new trunk.
CONFIGURATION > Network > Interface > Trunk > User
Configuration > Add
8 Go to CONFIGURATION > Network > Routing > Policy Route > Add to configure
a policy route.
Source Address: LAN1_SUBNET (192.168.11.0/24)
Destination Address: HQ_subnet (192.168.1.0/24)
Next-Hop: BO_vti_trunk
SNAT: none
CONFIGURATION > Network > Routing > Policy Route > Add