241/255
How to Perform and Use the Packet Capture Feature on the
ZyWALL/USG
This example shows how to use the Packet Capture feature to capture network traffic
going through the ZyWALL/USG’s interfaces. Studying these packet captures may
help you identify network problems.
Figure 358 ZyWALL/USG Packet Capture Feature Settings
Note: New capture files overwrite existing files of the same name. Change the File
Suffix field’s setting to avoid this. This example was tested using USG110 (Firmware
Version: ZLD 4.15).
To Next Page
Loading...
