Chapter 12 Remote Management
VMG4005-B50A/B60A User’s Guide
44
Figure 29 Maintenance > Remote Management > Trust Domain
The following table describes the fields in this screen.
12.3.1 Add Trust Domain
Use this screen to configure a public IP address which is allowed to access the VMG. Click the Add Trust
Domain button in the Maintenance > Remote Management > Trust Domain screen to open the following
screen.
Figure 30 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
Table 18 Maintenance > Remote Management > Trust Domain
LABEL DESCRIPTION
Add Trust
Domain
Click this to add a trusted host IP address.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trust IP address.
Table 19 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Address Enter a public IPv4 IP address which is allowed to access the service on the VMG from the WAN.
OK Click OK to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
