ZyXEL Communications VOP1372G-61 - Uploading the Firmware Via Boot Commands

Chapter 3 Troubleshooting
VOP1372G-61 User’s Guide
28
4 After a successful configuration file upload, type atgo to restart the line card.
3.3.2 Uploading the Firmware via Boot Commands
Usually you should use FTP with the MSC to upload the line card’s firmware. If you cannot manage
the line card from the MSC, use the following procedure to upload firmware to the line card.
1 Obtain the firmware file, unzip it and save it in a folder on your computer.
2 Connect your computer to the console port and use terminal emulation software configured to the
following parameters:
3 Pull out the line card and push it back in to restart it and begin a session.
4 When you see the
Press any key to enter Debug Mode within 3 seconds message,
press a key to enter debug mode.
5 Type
atba5 after the Enter Debug Mode message (this changes the console port speed to
115200 bps).
6 Change the configuration of your terminal emulation software to use 115200 bps and reconnect to
the line card.
7 Type
atur after the Enter Debug Mode message.
8 Wait for the Starting XMODEM upload message before activating XMODEM upload on your
terminal.
Bootbase Version: V1.00 | 03/23/2005 16:10:06
FLASH: AMD 32M
Hardware Version:
Serial Number:
RAM: Size = 133120 Kbytes
ZyNOS Version: V3.97(UHE.0) | 05/19/2011 11:56:26
Press any key to enter debug mode within 3 seconds.
...........
Enter Debug Mode
atlc
Starting XMODEM upload (CRC mode)....
CCCC
Total 393216 bytes received.
Erasing...
...........................................................................
.....OK
atgo
EXAM
PLE
• VT100 terminal emulation • 9600 bps
• No parity, 8 data bits, 1 stop bit • No flow control