Chapter 16 Firewall
VSG1432-B101 Series User’s Guide
223
Select Protocol Select the transport layer protocol that defines your customized port
from the drop-down list box. The specific protocol rule sets you add in
the Security Settings > Firewall > Protocol > Add screen display
in this list.
If you want to configure a customized protocol, select Specific
Protocol.
Protocol This field is displayed only when you select Specific Protocol in
Select Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, or ICMP) that defines your
customized port from the drop-down list box.
Custom Source
Port
This field is displayed only when you select Specific Protocol in
Select Protocol.
Enter a single port number or the range of port numbers of the source.
Custom
Destination Port
This field is displayed only when you select Specific Protocol in
Select Protocol.
Enter a single port number or the range of port numbers of the
destination.
Policy Use the drop-down list box to select whether to discard (DROP), deny
and send an ICMP destination-unreachable message to the sender of
(REJECT) or allow the passage of (ACCEPT) packets that match this
rule.
Direction Use the drop-down list box to select the direction of traffic to which
this rule applies.
Enable Rate Limit Select this check box to set a limit on the upstream/downstream
transmission rate for the specified protocol.
Specify how many packets per minute or second the transmission rate
is.
Scheduler Rules Select a schedule rule for this ACL rule form the drop-down list box.
You can configure a new schedule rule by click Add new rule. This
will bring you to the Security Settings > Scheduler Rules screen.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 69 Security Settings > Firewall > Access Control > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
