ZyXEL Communications ZyWALL USG FLEX 100 - Apply Configuration File on Active Device (Device 1)

750/782
www.zyxel.com
It supposed to be same as original active device (Device 1). We can check by CLI
Router > psm
Router(psm)# atsh
If virtual mac and serial are correct, then proceed to upload configuration file
on active device (Device 1).
On device 1, go to MAINTENANCE > File Manager > Configuration File and
upload configuration file.
Apply configuration file on active device (Device 1)
Connected serial cable to active device (Device 1) and apply configuration file
via CLI