2 3
11. Slots and openings in the cabinet are provided for ventilation and to ensure
reliable operation of the product and to protect it from overheating. Do not block
or cover these openings.
12. Unplug the product during lightning storms or when unused for long periods of
time.
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
WARNING:
Cancer and Reproductive Harm - HYPERLINK "http://www.
P65Warnings.ca.gov."
For more information go to HYPERLINK "http://www.1byonebros.com/Compliance/
Prop65"
Product Description
1
2
3
4
5
7
8
9
11
10
12
13
14
15
16
17
18
22
24
26
23 25
27
19
20
21
1. Motor Pulley
2. Drive Belt
3. Turntable Spindle
4. Turntable Sub-platter
5. Turntable Platter
6. Lid Hinge
7. Anti-skating Weight
8. Counterweight
9. Anti-skating Stick
10. Tonearm Rest
11. Tonearm Lift Lever
12. Tonearm Clip
13. Volume Control
14. Indicator
15. 33/45RPM Selector
16. Play/Stop Button
17. Mode Button
18. Stylus Cartridge
19. Ground Connector
20. Phono & Line Out Jacks
21. Phono & Line Out Switch
22. USB Port for PC Link
23. Power Cord Jack
24. External Speaker Jacks
25. Power Switch
26. Speaker Jack -
27. Speaker Jack +
To Next Page
Loading...
Need help?
General
