247securityinc.com
1.866.693.7492
Camera Connectors
The ZEUS TITAN supports a maximum of 16 cameras. Eight cameras use Micro-t connectors
that carry video, audio, and infrared illumination. Also included in each camera connection is
DV12V Out to power the camera. You can refer to the rear cover of the DVR for the camera
assignments of each connector. When any of the cameras are not connected properly – for
instance, loose cables, unplugged etc. – TITAN noties the end-users with “blue screen and
OSD info” on the preview screen. Camera inputs are labeled “CAM#1 – CAM#8”.
The remaining 8 cameras must be IP cameras connected to the POE connections.
CONNECTIONS
I/O CAN
This optional connector provides 3 additional digital inputs, labeled as DI_6, DI_7 and DI_8.
These can be assigned to any sensors, up to 3 sensors can be wired to this connector. This
connector also provides +12VDC OUT on pin 4 with a built-in 0.75A fuse. An optional second
I/O cable is required.
GP I/O (General Purpose Input/Output)
This connector provides 5 digital inputs and 1 digital output. The digital inputs are labeled as
DI_1, DI_2, DI_3, DI_4 and DI_5. The digital output is labeled as DO_3. End-users can assign
any sensors to one of these digital input signals. Up to 5 sensors can be wired to this connector.
Alternatively, one alarm (LED, Siren, etc.) is available on the digital output.
D-SUB 44PIN Connector
This multi-function connection carries several I/O connections, including:
• GPS receiver
• USB
• TAB101
• Additional POE
DIV, GPS, LTE, WIFI
The “DIV” connection is for future use. The remaining three are individual antenna connections
as indicated.
POE#1 and #2
For IP cameras.
EMR – Event Marker input
This connection is for the included Event Marker cable.
247securityinc.com | 1.866.693.7492 | 1455 Alderman Drive, Alpharetta GA 30005, USA
Pg.44 of 47
To Next Page
Loading...
