23
8
Kit-Volume (per channel)
EQ selects if the drum channel passes through the equaliser or not.
It is only available when the KIT-EQ-BUS parameter is set to Drum.
(Note: the channel direct out does not pass through the equaliser.)
FX sets the effect send volume. This is taken after the main volume
(so called post-fader).
BAL sets the balance for stereo sounds.
VOL sets the drum volume. This volume is duplicated on the KIT-
DRUM page. Note that the volume in the mix is affected by the drum
mix volume as well (UNIT-MIX page).
To Next Page
Loading...
