2N Access Unit M - Device Control; Signaling of Operational Statuses

2N TELEKOMUNIKACE a.s., www.2n.cz 41/56
Dynamic IP Address Setting
Follow the instructions below to switch on the (DCHP ON):Static IP address mode
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the
acoustic signal can be heard (approx. 15–35 s).
Wait until the red LED goes off and the acoustic signal can be heard
(approx. for another 3 s).
Wait until the green LED goes off and the red LED goes on again and the
acoustic signal can be heard (approx. for another 3 s).
Release the RESET button.