2N Access Unit M - Mechanical Parameters

2N TELEKOMUNIKACE a.s., www.2n.cz 46/56
7. Technical Parameters
Audio
1 W / 8 ΩLoudspeaker:
Power Supply
12 V ±15 % / 1 A
PoE 802.3af (Class 0–12.95 W)
Interface
10/100BASE-TX with Auto-MDIX, RJ-45 female (pigtail)LAN:
Cat-5e or higherRecommended cabling:
DHCP opt. 66, SMTP, 802.1x, TFTP, HTTP, HTTPS, SyslogSupported protocols:
NO/NC contact, up to 30 V / 1 A AC/DCPassive switch:
8 to 12 V DC according to power supply (PoE: 10 V; Active switch output:
adapter: supply voltage minus 2 V), up to 400 mA
part of Tamper switch: 2N Access Unit M
Inputs (Input 1,2): passive/active mode (−30 V to +30 V DC)
OFF = open or U > 1.5 V
in
ON = short-circuited or U < 1.5 V
in
RFID card reader
Frequency: 13.56 MHz & 125 kHz
Supported 13.56 MHz cards (card serial number is only read):
ISO14443A (Mifare, DESFire)
PicoPass (HID iClass)
FeliCa
ST SR(IX)
2N Mobile Key
®
HID SE ((Seos, iClass SE, Mifare SE) for secured cards only)