DTMF
Character
FUNCTION
to
These digits are interpreted as a password beginning - for switch control.
Notes
These commands do not work in the Automatic Multiple Number Dialling
mode without Confirmation!
The above-mentioned commands due to poor may not be accepted
connection if sent during a message. To avoid this, press the button
during the time of silence (between messages).
Survey of Messages
The table below includes a survey of language versions for standard announcements.
English is selected by default. To select another language, use parameters 976 and
977.
Value of
parameter
976
Language
selection –
English
version
End of call
message
Outgoing call message
ID message.Parameter
975 must contain digit
2, 3 or 5
Confirmation
message. Parameter
975 last digit = 5
0 Tone signal off off
1
(defaultvalue)
English Attention, your
call is being
terminated.
Communicator
number.......... is calling .
Connection
confirmed.
2 German Achtung, das
Gespräch wird
beendet.
Es ruft das
Notruftelefon
Nummer……an.
To Next Page
Loading...
