|
1" Faux Wood Blinds1
GETTING STARTED
Steel Tape Measure
Power Drill and
Drill Bits
Awl (or tool for
starting a screw hole)
Level
Pencil
Flathead & Phillips
Screwdriver
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
A few simple tools are required:
1" FAUX WOOD BLINDS
STANDARD HARDWARE
End Brackets
(Open Position LH & RH)
Screws
Center Support
Valance Clips
OPTIONAL HARDWARE
Spacers
(one spacer
per bracket)
Hold Down Brackets
with Screws
Extension Bracket
Valance Returns
Glue
To Next Page
Need help?
General
