1
|
Honeycomb Shades UltraLift Cordless™
BRACKET INFORMATION
OPTIONAL HARDWARE
The brackets you received with your product are required for
proper installation. Brackets should be installed 2" from each
end. Any additional brackets will need to be evenly spaced
between the two end brackets.
GETTING STARTED
STANDARD HARDWARE
A few simple tools are required:
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
Steel Tape Measure
Power Drill and
Drill Bits
Awl (or tool for starting
a screw hole)
Level
Pencil
Flathead & Phillips
Screwdriver
INSIDE MOUNT
Hold Down Brackets
with Screws
• The brackets are mounted flat against the top sill surface.
Place the bugle head screw through the hole closet to the
front of the bracket. To fully recess the shade requires a flat
surface with a minimum depth of 1
3
/
4
". Shallow mountain
requires
1
/
2
" minimum.
• Additional brackets, if included, are REQUIRED for proper
installation and should be installed evenly spaced between
the two end brackets.
• Proceed to “Shade Installation”.
PM-041
Extension Bracket
Screws
Mounting Brackets
1"
1
3
/
4
"
Spacers
HONEYCOMB SHADES
UltraLift Cordless™
To Next Page
Need help?
General
