3Com 4200G PWR - Page 25

3Com Switch 4200G Family 25
Command Reference
mkdir
Use the mkdir command to create a directory in a specified directory of a specified storage device.
User view
mkdir
Use the mkdir command to create a directory on the remote SFTP server.
FTP Client view
monitor-port
Use the monitor-port command to configure the destination monitor port.
Ethernet Port view
more
Use the more command to display the content of a specified file.
User view
move
Use the move command to move a file to a specified directory. You can also assign a new name for the file.
User view
name
Use the name command to set a name for the assigned VLAN.
VLAN view
name
Use the name command to set a name for the assigned VLAN.
VLAN view
nas-ip
Use the nas-ip command to set the source IP address used by the switch to send RADIUS packets.
RADIUS Scheme view
ndp enable
Use the ndp enable command in system view to enable NDP globally on the switch. When being executed
in Ethernet port view, this command enables NDP for an Ethernet port.
System view
Ethernet Port view
ndp timer aging
Use the ndp timer aging command to set how long a device will hold the NDP packets received from the
local device. After the aging timer expires, the device will discard the received NDP neighbor node
information.
System view
ndp timer hello
Use the ndp timer hello command to define how often to transmit the NDP packets.
System view
nm-interface vlan-interface
Use the nm-interface vlan-interface command to configure an NMS interface of the management
device.
Cluster view
ntdp enable
Use the ntdp enable command in system view to enable NTDP globally. When being executed in Ethernet
port view, this command enables NTDP for an Ethernet port.
System view
Ethernet Port view
ntdp explore
Use the ntdp explore command to start topology information collection manually.
User view
ntdp hop
Use the ntdp hop command to set a range (in terms of hop count) for topology information collection.
System view
ntdp timer
Use the ntdp timer command to configure the interval to collect topology information.
System view
ntdp timer hop-delay
Use the ntdp timer hop-delay command to set the delay time for a switch to forward topology-collection
request packets.
System view