3Com 4200G PWR - Choosing the Correct Cables

28 3Com Switch 4200G Family
Command Reference
port-security ntk-mode
Use the port-security ntk-mode command to set the packet transmission mode of the Need to Know
(NTK) feature.
Ethernet Port view
port-security OUI
Use the port-security OUI command to set an OUI value for authentication.
System view
port-security port-mode
Use the port-security port-mode command to set the security mode of the port.
Ethernet Port view
port-security timer disableport
Use the port-security timer disableport command to set the time during which the system temporarily
disables a port.
System view
port-security trap
Use the port-security trap command to enable the sending of the specified type(s) of trap messages.
System view
port trunk pvid vlan
Use the port trunk pvid vlan command to configure the default VLAN ID for a trunk port.
Ethernet Port view
port trunk permit vlan
Use the port trunk permit vlan command to add a trunk port to one VLAN, a selection of VLANs, or all
VLANs.
Ethernet Port view
primary accounting
Use the primary accounting command to set the IP address and port number for the primary accounting
server.
RADIUS Scheme view
primary authentication
Use the primary authentication command to configure the IP address and port number for the primary
RADIUS authentication/authorization server.
RADIUS Server Group view
priority
Use the priority command to set the priority of Ethernet port.
Ethernet Port view
priority trust
Use the priority trust command to configure the precedence mapping mode on the port of the switch.
Ethernet Port view
protocol inbound
Use the protocol inbound command to configure the protocols supported in the current user interface.
VTY User Interface view
protocol inbound
Use the protocol inbound command to specify the protocols supported by the user interface.
User Interface view
protocol-priority protocol-type
Use the protocol-priority command to set the global traffic priority that applies to a given protocol.
System view
protocol-vlan
Use the protocol-vlan command to specify a VLAN is a specified type of protocol-based VLAN.
VLAN view
public-key-code begin
Use the public-key-code begin command to enter public key edit view and input the client public key.
Public Key view
public-key-code begin
Use the public-key-code begin command to enter public key edit view and set server public keys.
Public Key view