3Com 4200G PWR - IP Configuration

36 3Com Switch 4200G Family
Command Reference
ssh client first-time enable
Use the ssh client first-time enable command to configure the client to run the initial authentication.
System view
ssh server authentication-retries
Use the ssh server authentication-retries command to set authentication retry number for SSH
connections.
System view
ssh server timeout
Use the ssh server timeout command to set authentication timeout time for SSH connections.
System view
ssh user assign rsa-key
Use the ssh user assign rsa-key command to allocate public keys to SSH users.
System view
ssh user authentication-type
Use the ssh user authentication-type command to define on the server the available authentication type
for an SSH user.
System view
ssh user service-type
Use the ssh user service-type command to specify service type for a user.
System view
ssh2
Use the ssh2 command to enable the connection between SSH client and server, define key exchange
algorithm preference, encryption algorithm preference and HMAC algorithm preference on the server and
client.
System view
startup bootrom-access enable
Use the startup bootrom-access enable command to specify a switch to prompt for the customized
password before entering the BOOT menu.
User view
startup saved-configuration
Use the startup saved-configuration command to specify the main or backup configuration file for a
switch to start the next time.
User view
state
Use the state command to configure the state of the current ISP domain/current user.
ISP Domain view
Local User view
RADIUS view
state
Use the state command to configure the state of RADIUS server.
RADIUS Scheme view
stop-accounting-buffer enable
Use the stop-accounting-buffer enable command to enable the switch to buffer the stop-accounting
requests that bring no response.
RADIUS Scheme view
stopbits
Use the stopbits command to set the stop bits of the user interface.
User Interface view
stp
Use the stp command to enable or disable MSTP globally or for a port.
System view
Ethernet Port view
stp bpdu-protection
Use the stp bpdu-protection command to enable the BPDU protection function.
System view
stp bridge-diameter
Use the stp bridge-diameter command to set the network diameter of a switched network, which is
represented in terms of the maximum number of switches between any two terminals in a switched network.
System view