3Com 4200G PWR - Manually Configuring IP Information

3Com Switch 4200G Family 37
Command Reference
stp config-digest-snooping
Use the stp config-digest-snooping command to enable the digest snooping feature.
Ethernet Port view
stp cost
Use the stp cost command to set the path cost of a port in a spanning tree instance.
Ethernet Port view
stp edged-port
Use the stp edged-port command to configure the current Ethernet port as either an edge port or a
non-edge port.
Ethernet Port view
stp interface
Use the stp interface command in system view to enable or disable MSTP for specified ports.
System view
stp interface config-digest-snooping
Use the stp interface config-digest-snooping command to enable the digest snooping feature.
System view
stp interface cost
Use the stp interface cost command to set the path cost of specified ports in a specified spanning tree
instance.
System view
stp interface edged-port
Use the stp interface edged-port command to configure the specified Ethernet ports to be either edge
ports or non-edge ports.
System view
stp interface loop protection
Use the stp interface loop-protection command to enable the loop prevention function.
System view
stp interface mcheck
Use the stp interface mcheck command to perform the mCheck operation for specified ports.
System view
stp interface no-agreement-check
Use the stp interface no-agreement-check command to enable the rapid transition feature on a specified
port.
System view
stp interface point-to-point
Use the stp interface point-to-point command to specify whether the specified Ethernet ports are
point-to-point links.
System view
stp interface port priority
Use the stp interface port priority command to set the port priority of specified ports in a spanning
tree instance.
System view
stp interface root-protection
Use the stp interface root-protection command to enable the root protection function for specified
ports.
System view
stp interface transmit-limit
Use the stp interface transmit-limit command to set the maximum number of BPDUs that each
specified port can send within a Hello time interval.
System view
stp loop-protection
Use the stp loop-protection command to enable the loop prevention function for the current port.
Ethernet Port view
stp max-hops
Use the stp max-hops command to set the maximum hop count of the MST region to which the switch
belongs.
System view