3-7
e Figure 3-14 Bind the radio to and enable the wireless servic
z Click the Bind link in the Wireless Service column, select the target radio, and click Bind.
z Select the psk check box.
z Click Enable.
5) Enable 802.11n (2.4GHz) radio (By default, 802.11n (2.4GHz) radio is enabled. Therefore, this
step is optional.)
Select Radio > Radio from the navigation tree to enter the Radio page. Make sure that 802.11n
(2.4GHz) radio is enabled.
Configuration verification
The same PSK pre-shared key is configured on the client. The client can successfully associate with the
AP (as shown in
Figure 3-15)and can access the WLAN network.
Figure 3-15 The client associates with the AP
Configuration guidelines
When satisfied with the configuration Save Configuration to File to ensure it is not lost when the Access
Point restarts.
Local MAC Authentication Configuration Example
Network requirements
As shown in Figure 3-16, configure the fat AP to perform MAC authentication on the client.
To Next Page
Loading...
