3
INSTALLING THE ROUTER
There are two ways you can install your router:
■ On a vertical surface
■ On a workbench
Mounting the Router
on a Vertical Surface
The Router 3000 series routers can be mounted onto a vertical surface using 2
pan-head screws and 2 brackets on the base of the router using the following
procedure:
1 Mark the bracket positions on the wall.
2 Screw 2 pan-head screws into the marked positions on the wall or the vertical
surface, so that the screws match the 2 brackets on the base of the router. Each
screw should project 0.6 cm (.25 in) from the wall or the surface.
3 Hang the router on the screws by the two brackets.
4 Make sure that the front panel LEDs are easily visible to the operator
5 Fix the external power supply of the router to prevent the power cords from falling
down
See Figure 1 and Figure 2 for illustrations of this procedure.
Figure 1 The Bottom of the Router
120mm
4.72in
To Next Page
Loading...
