Advanced 107
■ Gateway — the Router used to route data to the network specified by
the network address.
■ Interface — select the interface.
Note that you should only configure either the Gateway information or
select the Interface. After you have finished making changes to the table,
click Apply.
Here is an example of setting up a static route.
■ IP address of your PC: 10.1.4.52
■ Subnet mask: 255.255.252.0
■ Default Gateway: 10.1.4.254
■ Network Address: 10.1.4.0
Figure 84 Add Static Route Example Screen
To Next Page
Loading...
