VPN 123
Figure 100 Add new PPTP VPN Tunnel Screen
1 Set the Tunnel Type to PPTP.
2 Enter a descriptive name for the tunnel in the Tunnel Name field.
3 Enter the User name and Password.
4 Enter the Idle Timeout value.
5 Set the PPTP Type Setting to PPTP Server, or PPTP Client.
■ if you set the type as PPTP Client, then set the Local Type Setting to
Network or Host, then enter the Remote Server IP. Check the Auto
reconnect box, if you want to auto-reconnect after disconnection.
■ if the PPTP Type Setting is set to PPTP Server, go to step 6.
6 Check the box to enable the Remote Network Setting, and then enter the
Remote Network Address, and Remote Subnet Mask information.
7 When the PPTP Type Setting is set to PPTP Client, you would then need to
enter the Pre-shared Key information.
8 Click Apply.
To Next Page
Loading...
