What does it mean if the 3M ESPE Elipar S10 Dental equipment handpiece flashes red while charging?
If the power level display on your 3M ESPE dental handpiece flashes red while it's in the charger, it indicates a charging problem. This usually means the battery is defective or has reached the end of its useful life. Replace the battery to solve this issue.
Why does the light not turn on and an error signal sound on my 3M ESPE Elipar S10?
If the light emission doesn't start when you press the START button and a 2-second error signal sounds on your 3M ESPE dental handpiece, it means the handpiece has overheated during use. Allow the handpiece to cool for 3 minutes before attempting another exposure by pressing the START button.
What to do if the 3M ESPE Dental equipment handpiece flashes red and won't activate?
If the power level display on your 3M ESPE dental handpiece flashes red, the exposure is interrupted, and the device goes into sleep mode, it means the battery doesn't have enough charge. Place the handpiece in the charger to recharge the battery.
How to turn on a 3M ESPE Elipar S10 Dental equipment handpiece after long storage?
If your 3M ESPE dental handpiece won't turn on after a long period of non-use, the battery likely doesn't have enough charge. Place the handpiece in the charger and allow it to recharge.
Why is the charge level display on my 3M ESPE Elipar S10 handpiece glowing red?
If the charge level display on your 3M ESPE dental handpiece glows red steadily, it indicates that the remaining battery charge is only adequate for approximately 5 to 10-second exposure cycles. To resolve this, place the handpiece in the charger and recharge the battery.
Details the intended uses and applications of the Elipar S10 curing light.
Provides detailed specifications for the charger and handpiece.
Specifications for the charging unit, including voltage and power.
Specifications for the handpiece, including power source and wavelength.
Instructions for properly inserting the battery into the handpiece.
Explains how to choose and set the light exposure time.
Step-by-step instructions for turning the curing light on and off.
Guidance on correctly positioning the light guide for optimal polymerization.
Describes how to measure and check the light intensity using the charger.
Step-by-step guide for safely inserting and removing the battery.
Recommendations for caring for the handpiece and battery.
Detailed instructions for cleaning and disinfecting the light guide.
Detailed procedures for manual cleaning and disinfection of the light guide.
Information on automated cleaning and disinfection processes.
Guidelines for effective sterilization procedures, primarily steam.
Steps to perform a check of the light guide before reuse.
Instructions for cleaning the charger, handpiece, and glare shield.
Guidance on how to store the handpiece when not in use for extended periods.
Provides information and declarations regarding electromagnetic emissions from the device.
Specifies recommended distances for RF equipment to maintain proper operation.
General| Brand | 3M ESPE |
|---|---|
| Model | Elipar S10 |
| Category | Dental equipment |
| Language | English |
To Next Page
