3M 1 Piece - Page 10

10
Operating Details
LEDs
Power
PowerPower
Power
This LED indicates the condition of the 1 Piece (Gen 4) battery.
Prior to Activation:
Prior to Activation:Prior to Activation:
Prior to Activation:
Before activating the device, the officer should conduct a battery test. To do this,
simply hold down the silver activation button for three seconds and observe the
condition of the Battery LED.
• If the “PWR” LED is green
greengreen
green, there is a sufficient charge to activate the 1 Piece
(Gen 4).
• If the “PWR” LED is red,
red,red,
red, or does not light up at all, the 1 Piece (Gen 4) needs to
be charged.
After Activation:
After Activation:After Activation:
After Activation:
• If the “PWR” LED is blinking green
greengreen
green, there is a sufficient charge.
• If the “PWR” LED is blinking red
r
edred
red, the 1 Piece (Gen 4) needs to be charged.
1 Piece
1 Piece 1 Piece
1 Piece (Gen 4)
(Gen 4)(Gen 4)
(Gen 4) on Charger:
on Charger:on Charger:
on Charger:
When the 1 Piece (Gen 4) is connected to the charger, the Power LED will be solid (not
flashing) green
greengreen
green or red
redred
red.
• If the LED is red:
red:red:
red: The 1 Piece (Gen 4) is not fully charged
not fully chargednot fully charged
not fully charged and should not be
disconnected from the charger
• If the LED is green
greengreen
green: The 1 Piece (Gen 4) battery has been
has been has been
has been completely charged
completely chargedcompletely charged
completely charged
and the charger may be disconnected
• When the 1 Piece (Gen 4) is connected to the charger, it will vibrate once
indicating a good connection. When the battery is fully charged, the 1 Piece
(Gen 4) will vibrate once indicating that it is okay to remove from the charger.